Attic Mold Removal in Franklin, NJ:
Fan Rerouting, NFA Correction, Borate Protection

Two prior inspectors told us our Franklin attic had mold that needed full sheathing replacement — over $12,000 in quotes. Cheap Mold Removal measured MC% on every panel, identified 90% of the darkened panels as sapstain (MC% consistently below 14%) and only 8 panels near the north eave with active growth (MC% 23–26%). They HEPA-removed and borate-treated those 8 panels, rerouted the bathroom fan that was terminating 4 feet short of the exterior cap, and baffled the blocked eave bays on the north side. Total remediation cost was $1,800. Post-clearance confirmed clean. They saved us $10,000-plus from unnecessary full replacement.

What stood out was the CFM measurement on the bathroom fans. One fan measured 19 CFM at discharge — about 40% of its nameplate rating — because the flex duct had too many bends and an undersized exterior cap creating back pressure. Cheap Mold Removal rerouted it with shorter duct, fewer bends, and a proper cap — measured 52 CFM at the exterior cap after rerouting. That 33 CFM difference is why that bathroom was growing mold on the ceiling joists above it. Fixed the cause, not just the symptom.

Cheap Mold Removal distinguished the sapstain from active mold on our Franklin, NJ property — something that was critical for our real estate transaction. The seller's original inspector had reported 'black mold throughout the attic.' Cheap Mold Removal's assessment found active mold on only 12 panels near an improperly terminated exhaust fan — the rest was pre-existing sapstain. Written report supported renegotiating the remediation allowance to reflect actual active mold extent.